IAI America TTA - Manual (Page 61)

-61/85-
4-3-43. Position Data Clear 2 (Old: Point Data Clear 2) (26EH)
Function: Clear position data for the number of clear positions from the clear start position number. (Position data comments cannot be cleared.)
Data name Data range (value)
Data size
[bytes]
Cumulative
bytes [bytes]
Endian Sign extension
Unit Description Remarks
Big Little Yes No
Command
Header '!' 1 1  
Station 'XX(h)' 2 3  
Message ID '26E(h)' 3 6  
Clear start position
data number
'XXXX(h)' 4 10  
Number of clear
position data
'XXXX(h)' 4 14  
SC 'XX(h)' 2 16  
CR 0Dh 1 17  
LF 0Ah 1 18  
Normal
response
Header '#' 1 1  
Station 'XX(h)' 2 3  
Message ID '26E(h)' 3 6  
SC 'XX(h)' 2 8  
CR 0Dh 1 9  
LF 0Ah 1 10  
Error
respon
se
Error response
format Refer to the error
response format.
10 10  
(Note 1) Add H (or h) at the end of each data expressed in hexadecimal notation. If there is no H or h at the end, the data is considered a decimal.
(Note 2) Data enclosed in single quotation marks indicates an ASCII code. Data is a hexadecimal ASCII code if (h) is added before the closing quotation mark, or a decimal ASCII code if (d) is
added before the closing quotation mark.