Gilderfluke&Co old MACs 8 bit Digital Audio System User Manual

Page 64

EXAMPLE: to put card 00 into ECHO ALL mode:

e 0 0

EXAMPLE: a 'Start Track# 00' command will echo: t00

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥

"f"

Exit Echo All Mode:

This command takes all cards in the system out of ECHO ALL MODE.

EXAMPLE: to take any and all cards out of ECHO ALL mode:

"g"

Enter Echo Mode:

This command puts all the cards in the system into ECHO MODE. When in this mode, all track-
specific commands are echoed by the card addressed by the command. This is the type of
echo mode which best verifies the proper operation of all the cards in the digital audio
system.

EXAMPLE: to put card 00 into ECHO mode:

g 0 0

EXAMPLE: a 'Start Track# 00' command will echo: t00

"h"

Exit Echo Mode:

This command takes all cards in the system out of ECHO MODE.

EXAMPLE: to take any and all cards out of ECHO mode:

"i" (TRACK#)

Track Status Report:

This command responds with a stream of ASCII HEX data containing the current status of the
card specified by the TRACK#:

BYTE 1 &2 = LED Port Status

BIT 0 = MUTE STATUS (1 = muted)
BIT 1 = DELAY STATUS (1 = in delay)
BIT 2 = HALF-MUTE STATUS (1 = half-muted)
BIT 3 = not used
BIT 4 = RUN STATUS (1 = running)
BIT 5 = STATUS OUTPUT STATUS (1 = on)
BIT 6 = PA STATUS (1 = on)
BIT 7 = REPEATER CLOCK ENABLED (1 = on)

BYTE 3 & 4 = INPUT STATUS

BIT 0 = A INPUT STATUS (1 = closed)
BIT 1 = B INPUT STATUS (1 = closed)
BIT 2 = PB INPUT STATUS (1 = closed)
BIT 3 = not used
BIT 4 = not used
BIT 5 = not used
BIT 6 = not used
BIT 7 = not used

BYTES 5 through 12 = Memory Address Status BITS 10 THROUGH 42

BYTE 13 & 14 = Dipswitch #1 Status
BYTE 15 & 16 = Dipswitch #2 Status
BYTE 17 & 18 = Aux. Port Status
BYTE 19 & 20 = PA TRUNKS 8 through 15
BYTE 21 & 22 = PA TRUNKS 0 through 7

ILDERFLUKE

& C

. ¥ 205 S

OUTH

LOWER

. ¥ B

URBANK

, C

ALIF

. 91502-2102 ¥ 818/840-9484 ¥

FAX

818/840-9485