Ransburg RMA Dual Purge Direct A12300 - Manual (Page 40)

AIR FILTRATION REQUIREMENTS
Filter Model No.
HAF-503
RPM-417
RPM-418
HAF-15 Element,
One
RPM-32 Elements,
Carton of 4
RPM-33 Elements,
Carton of 8
Pre-filter, removes coarse amounts of oil, moisture & dirt.
Used upstream of RPM-417 pre-filter (used in systems
with poor air quality).
Pre-filter, coalescing type, 136 SCFM, 98.5% efficiency
particulate removal .3 to .6 micron, max. aerosol passed
1.0 micron, max. solid passed .4 micron (dependent upon
scfm requirement per applicator, one RPM-417 can be
used with up to three RMA-303 assemblies).
Bearing air filter, coalescing type, 19 SCFM, 99.995% ef-
ficiency particulate removal .3 to .6 micron, max. aerosol
passed .6 micron, max. solid passed .2 micron (one per
applicator).
Description / Specifications
Replacement
Element Part No.
RMA-303 Dual Purge/Direct Charge - Installation
35
Ransburg
LN-9263-08.5
† Air must be properly filtered to ensure
extended turbine life and to prevent con-
tamination of the paint finish. Air which
is not adequately filtered will foul the tur-
bine air bearings and cause premature
turbine failure. The correct type of filters
must be used in an RMA-303 system.
The filter elements must be replaced on
a regular schedule to assure clean air.
† It is the end user’s responsibility
to ensure clean air at all times. Turbine
failure resulting from contaminated
air will not be covered under warranty.
† "Air Filtration Requirements" shows the
pre-filter(s) and bearing air filter which are
recommended for use in RMA-303 systems.
If other filters are incorporated in the system,
the filters to be used must have filtering capac-
ities equal or better than those shown in the
"Air Filtration Requirements" in this section.
† The user must ensure the bearing air
supply is not inadvertently turned off while
the RMA-303 air motor is turning. This will
cause air bearing failure.
C A U T I O N
!
NOTE
† Each applicator must have its own filter
for bearing air. Recommended: RPM-418
or equivalent.