E-Mon E-D5-600800-S*SPL3-V3KIT3 - Manual (Page 6)

DIN-MON™ SMART METER
62-0442—04 6
1.0 INTRODUCTION
The Din-Mon™ meter is used to monitor electric power usage of individual loads after
the utility meter and store kW and kVAR data for automatic meter reading.
The model D2 kWh meter has an RS-485 communication for remote reading.
The model D5 Advanced kWh meter has dual protocols with Ethernet or LonWorks
communications in addition to RS-485.
Refer to the Technical Specification section for details.
Fig. 1. Din-Mon TM Meter (top angle view with covers).
Installation must only be performed by qualified personnel and in accordance with
these instructions and all applicable local and national electrical codes. E-Mon and its
representatives assume no responsibility for damages or injury resulting from the
improper installation of this meter.
Fig. 2. Meter Name Plate (side view with cover removed).