Aastra Telecom SIP 480I - Manual (Page 487)

How to Create an XML Application
41-001129-00 Rev 09, Release 1.4.1 G-17
Creating an XML Application
Appendix G Execute Commands Object (for executing XML commands)
An AastraIPPhoneExecute object on the IP phones allows the phone to execute
commands using XML. The phones support the following execute object
commands:
• Reset - This command waits until the phone is idle and then executes a reset.
• NoOp - This command has no affect on the IP phone. It is made up of a blank
URI. You can use this feature when you need to press a key on the phone to
access a feature, and it is not necessary to display anything.
Since the server forces phone firmware changes, the AastraIPPhoneExecute
object was implemented to send the reset command to the phone.
AastraIPPhoneExecute Object Structure
The AastraIPPhoneExecute object describes the structure of the XML document
that is used to send a command to the phone. It delivers multiple execution
requests to the phone. The basic structure of the AastraIPPhoneExecute object is:
Using the Reset Command
The tag can be entered with the command the phone
should execute. Upon receiving an AastraIPPhoneExecute object, the phone
begins executing the URL or URI specified.