Aastra Telecom SIP 480I - Manual (Page 24)

Firmware and Configuration Files
1-8 41-001129-00 Rev 09, Release 1.4.1
IP Phone Administrator Guide
Overview
References
For setting up and configuring the IP phone using either the IP phone UI, the
Aastra Web UI, or the configuration files, see
Chapter 4, “Configuring the IP
Phones.”
For information about the softkey and programmable key parameters, see
Appendix A, the section,
“Softkey/Programmable Key Parameters” on page A-93.
Installing the Firmware/Configuration Files
The following procedure describes how to install the firmware and configuration
files.
Step Action
1 If DHCP is disabled, manually enter the configuration server’s IP address. For details on setting
DHCP, see Chapter 4, the section
“DHCP” on page 4-4 .
2 Copy the firmware file .st to the root directory of the configuration server. The IP
phone accepts the new firmware file only if it is different from the firmware currently loaded on the IP
phone.
Note: The attribute is the IP phone model (i.e., 480i.st, 9133i.st)
3 Copy the Aastra configuration files (aastra.cfg and .cfg) to the root directory of the
configuration server.
Note: The attribute represents the actual MAC address of your phone.
(i.e., 00085D030996.cfg).
4 Note: Restart tthe IP phone as described in the section, “How to Restart the IP Phone” on page .