Micromod MOD: 30ML Display Script Guide - Manual (Page 31)

MOD 30ML Display Guide
Display Basics
2 -25
Action Comment
19. Select the Formats tab, and select the
Add button
The Specify Format Data dialog box
appears
20. In the Name field, type: TotLine Type over the default entry FMT1
21. In the Format Type field, use the pull-
down menu to select Float 0.
The value will show as a floating-point
number with no decimal places.
22. Change the Entry Method field to None
using the pull-down menu.
No operator data entry is required for this
format.
23. Set the High Limit at 100000 by typing the
value in the High Limit field
This should correspond to the high limit
in the Totalizer block
24. In the Engineering Units field, type KLB. This represents “thousands of pounds”.
25. Close the dialog box using OK The format now appears on the formats
list.
26. Close the block using OK
Figure 2 .20.
Display Block
Formats - Totalizer
27. Connect the TC output of the TOT block
to Input 1 (I1, Total) of the Display block.
TC represents “Total Count” and will be
displayed on Line 2.
Figure 2 .21.
Block Connections
for displaying Total
TC TOTAL
28. Add the Display tag STM TOT to the
Display List in the Display Interface Block
as shown below.
You may also wish to use this as your
display to appear on power-up.
TOT DISP