Micromod Micro-DCI: 53IT5100A Indicator/Totalizer - Manual (Page 38)

3.5 FRONT PANEL PUSH BUTTON ALTERNATIVES
There are four alternative methods other than the front panel push buttons for accessing and
changing database parameters. All four methods to display and/or alter database parameters are
listed as follows:
1. Using an IBM PC compatible running the MC5FIG.EXE configuration program that is
supplied as part of the 53HC3300 software package. This procedure is included in the
Instruction Bulletin (IB 53HC3300) with the software.
2. Using an IBM PC compatible running the configuration program that is supplied as part
of the 53
MT6
000 software package. This procedure is included in the Instruction Bulle-
tin (IB 53
MT6
000) with the software.
3. Using an SUPERVISOR-PC with configuration software. This procedure is pro-
vided in the SUPERVISOR-PC Instruction Bulletin (IB 53SU5000).
4. Using the Hand Held Configurer (or any ASCII RS-232 terminal) connected to the
configuration port DIN plug on the front panel of the instrument. This procedure, using
the Hand Held Configurer, is described next in the remainder of this section.
Figure 3-11 illustrates the Hand Held Configurer and PC DIN plug cables necessary to configure
an instrument for the four alternative methods described. The PC cable type (9 pin or 25 pin) is de-
pendent upon the PC communications connector.
Section 3. Displays and Push Buttons
3-11