Luminex 100 IS User Manual, Version 2.3 - Manual (Page 66)

Luminex 100 IS User Manual Version 2.3
x
MAP Technology
5 - 24 PN 89-00002-00-071 Rev. C
Standards Tab The Standards tab lists all the batch tests with system comments
specific to each test. The detailed test information that is displayed
on the three tabs of the Analysis window is determined by the test
selected under the Standards tab.
The Standards tab displays the quantitative batch’s standard curve. It
displays qualitative batches as a graph plotting the assay standard.
Above the graphical information, the tab displays the formula that it
used to calculate batch data. Below the graphical information, the tab
displays the Standards and Controls values for the selected test.
Table 5-5. Error Categories
System and Assay Errors Sample Errors
• Instrument Not Calibrated
• Failed Verification (system lists
each failed control)
• Failed Control (verifier failed)
• Temperature Divergence from
Calibration Temperature
• Failed Curve Fit
• Analysis Error
• APD Temp Range Exceeded
• XYP Temp Unstable
• Low Voltage
• High Sheath Pressure
• Low Sheath Pressure
• Command Timeout
• Low Laser Power
• Cannot Calculate Inverse
Function
• Failed Std in Batch
• Insufficient Bead Count
• Sample High/Low
• Analyzer Error
• High Sheath Pressure
• Low Sheath Pressure
• Sample Timeout
• Sample Empty
• Cannot Calculate Inverse
Function
• Different Qualitative Results