Luminex 100 IS User Manual, Version 2.3 - Manual (Page 153)

Luminex 100 IS Maintenance Log Month(s): ________________________________________ Year: _______________
Maintenance Log
Procedure: Use this form to record information over a four-week period. Fill in the month(s) and year above. Fill in the dates in the first line of the table. For each item listed at the left, enter
your initials under each date that you perform the item.
Note: Follow your standard laboratory safety practices when cleaning or maintaining the system. Do not remove the instrument cover under any circumstances.
Dates
Daily maintenance
Startup
Initials: (for each item listed at the left, fill in your initials under each date that you perform the item)
Laser warmup
Check sheath fluid
Check waste level
Tighten sheath cap
Alcohol Flush (70% isopropanol or 70%
ethanol)
Wash twice (sheath fluid or distilled
water)
Shut down
Initials: (for each item listed at the left, fill in your initials under each date that you perform the item)
Sanitize (10% to 20% household
bleach solution)
Wash twice (water)
Loosen sheath cap
Turn system off (optional)
Weekly
Visual inspection
Date/Initials: Date/Initials: Date/Initials: Date/Initials:
Monthly
Clean sample probe
Date/Initials:
Wipe exterior surfaces Date/Initials:
Calibrate and verify Date/Initials:
Every six months
Replace air intake filter,
analyzer
Date/Initials:
Replace air intake filter, XYP Date/Initials:
Replace syringe plunger seal, or
syringe
Date/Initials:
Check analyzer ventilation filter Date/Initials:
Yearly
Replace sheath filter
Date/Initials:
As required
Replace fuses
Date/Initials:
Comments:
PN 89-00002-00-071 Rev. C