Luminex 100 IS Version 2.1 - Manual (Page 53)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 47
Figure 32. Selecting Template Commands
13. Select commands from the Available Commands list and move
them to the Template Commands list using the single arrow
pointing towards the template command button.
These commands are then part of the template and are always
performed in the order specified for any batch that uses this
template. Each well command is automatically assigned to the
next available well. Laboratory personnel running the batch can
not change these commands. Remember that if you have more
than one command that involves the reservoir, those commands
must use the same solution.
For a complete list of command descriptions, see Table 8,
“Available Commands” .
14. After you enter all the template information, check it carefully.
When all the information is correct, click Save to save the
template, then click Close to exit.