Luminex 100 IS Version 2.1 - Manual (Page 34)

Luminex 100 IS Developer Guide to xMAP Technology Version 2.1 x MAP Technology
28 PN 89-00002-00-062 Rev. A
The Apply Unit button applies the same unit value that you
entered on the first line to all other tests. For example, if you
enter the mg/uL value for the first Test Unit, then select the
Apply Unit button to make all test units mg/µL.
7. Enter the Number of Controls (assay) for this product and press
Enter key.
8. Enter the Reagent Name for each control in this product. Each
control reagent must test for every analyte (bead set) used in the
assay. See example in Figure 15.
9. After entering all the information, check it carefully. When all
the information is correct, click Save to save the product.
10. Click Close.
Assay Standards and
Controls (Both)
‹ To create a product that consists of assay standards and controls:
1. Click the Create Product button on the toolbar. The Create New
Product dialog box appears listing the existing products.
2. Select New to enter a new product into the system.
3. Select Both.
Note: If the reagent names are
similar, click the Apply Suffix
button to ensure that each
name is unique.