Luminex 100 IS Version 2.1 - Manual (Page 18)

Luminex 100 IS Developer Guide to xMAP Technology Version 2.1 x MAP Technology
12 PN 89-00002-00-062 Rev. A
Figure 3. New Advanced Batch—Bead Set Tab
8. Edit the Events and Caption field for each bead set. Edit the
Default Events field to change the default value. Click Apply to
All to apply the default value to all bead sets.
9. The bottom of the dialog is repeated from the General tab.
10. Define the Bead Events for this session. The default is Per Bead
or you may choose Total Beads. If you select Total Beads, edit
the adjacent field. You can determine the bead events on the
Bead Set Tab—Selection Shortcuts
Selected Column Select several rows, right-click the
Selected column, and then select/
deselect the desired rows.
Events Column Select several rows, right-click the
Events column, and apply “default
events” to your selection.
Caption Column Select several rows, right-click
Caption column, and reset the
caption to its default value.
Entire Column Select an entire column by clicking
the column heading (Selected,
Events, or Caption).