Luminex 100 IS Version 2.1 - Manual (Page 33)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 27
Figure 14. Creating Control Products
3. Select Control.
4. Enter the Product Number, Product Name, and Manufacturer
Name for the product.
5. Enter the Number of Tests for this product and press Enter key.
Each test represents an analyte (the bead ID for each test is
selected when creating the template using this product).
6. Enter the Test Name (analyte) and Test Units used for each test.
Using Apply Suffix and Apply Units buttons
If the test name is similar and the units are the same for each test,
after entering the first test name and unit, click the Apply Suffix
or Apply Unit buttons as appropriate.
The Apply Suffix button applies the number one to the first test
name. For each successive test name it applies the test name and
number at one increment higher than the previous test name. For
example: Suffix = Protein, then Test 1 is Protein 1, Test 2 is
Protein 2, and so on.
Select Control