Luminex 100 IS Version 2.3 - Manual (Page 47)

x
MAP Technology Using Luminex 100 IS 2.3 Software
PN 89-00002-00-072 Rev. C 5 - 5
Favorites. You can use the Favorites list to create a customized list
of often-used commands and templates. Items appear in alphabetical
order for easy locating. For more information on setting up the
Favorites list, see page 5-42.
Button Groups. Button groups are grouped according to function.
• The Daily Startup group contains the Warmup, Prime,
Alcohol Flush, and Wash Commands. For more information
on daily startup, see page 5-43. For more information on the
commands, see the Commands section on page 5-31.
• The Instrument Calibration group contains the CAL1,
CAL2, CON1, and CON2 buttons. For more information on
calibrating the system, see page 5-46. For more information
about these commands, see the Commands section on page 5-
31.
• The Batch Setup group contains the New Batch, New
Multibatch, and New Lot buttons. For more information on
creating and running batches and multibatches, see page 5-51.
For more information about these commands, see the
Commands section on page 5-31.
• The Reports and Analysis group contains the Analysis and
Print buttons. For more information on running reports and
analyses, see page 5-87. For more information about the
Analyses and Print commands, see the Commands section on
page 5-31.
• The Daily Shutdown group contains command buttons that
you can use when shutting down the system. For more
information on performing a daily shutdown, see page 5-97.
For more information on the Sanitize and Soak commands, see
the Commands section starting on page 5-31.
Run Batch Tab The Run Batch tab contains a microtiter plate and reservoir image,
XYP and DD temperature readbacks, a sheath pressure gauge, print
button, command list displaying batch commands and their status,
and plate and XYP command buttons. See Figure 5-4.