Luminex 100 IS Version 2.3 - Manual (Page 111)

x
MAP Technology Using Luminex 100 IS 2.3 Software
PN 89-00002-00-072 Rev. C 5 - 69
Figure 5-37. Plate Layout Tab
9. Select wells. To select a single well, click the well. To select
multiple wells in a group, click and hold the mouse button with
the cursor over the first well, then drag the cursor around the
desired wells. To select a row or column click the letter or
number of the row or column.
10. Select plate commands. Right-click over the selected wells to
display the Command menu. See Figure 5-38. Select the desired
command. The associated command symbol appears in the
designated plate well. To make a correction, select the wells
(selected wells are outlined in blue), right-click over the selected
wells to display the Command menu, and then click Clear
Selection from the list. Table 5-10 (following) lists Plate Layout
selection shortcuts.
Figure 5-38. Plate Layout Tab Command Menu
Note: Wells are always read
in rows (letters A to H) and
columns (numbers 1 to 12)
starting with A1. If partial col-
umns are selected they are
still read in the same order.