Brickcom OSD-200 20xp - Manual (Page 61)

57
A. Get User Information
All the user accounts registered to the network camera will be listed in
the zone in the form of User:Password
It indicates that the
login username is “User”, and the password is
“Password”.
B. Get User Privacy
Click on at the bottom of the page, and the
Administrator can view each user’s privileges as shown below:
User: 1:1:0:1
1:1:0:1= I/O access : Camera control : Talk : Listen (refer to Security )
Therefore, it denotes the user is granted privileges of I/O access,
Camera control and Listen.
7.15.3 Parameters
The Parameters function can be found under this path: System>
Parameter.
Click o n this item to view the entire system’s parameter setting such
as Camera Settings, Mask Information and Network Information.
7.16 Factory Default
The Factory Default setting can be found under this path: System> Factory
Default.
Users can follow the instructions on this page to reset the IP Camera to
factory default settings if needed.
A. Full Restore
Click on the button to recall the factory default settings.
Then the system will restart in 30 seconds.
NOTE- The IP address will be restored to default.