Brickcom OSD-200 20xp - Manual (Page 47)

43
The images of the duration will be uploaded to FTP when the
alarm input is triggered. The setting range is from 1 to 9999
seconds. Select to make the
images keep being uploaded to FTP during the trigger active until
the alarm is released. Set the Image frequency as the upload
frame rate. The setting range is from 1 frame to 15 frames.
NOTE- Make sure FTP configuration has been completed.
Refer to FTP for further details.
 Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail
address and configure various parameters. When the alarm is
triggered, event images will be sent to the appointed e-mail
address.
function allows users to check what
happened to cause the trigger. The frame
rate could be pre-determined.
On the other hand, is for users to upload
certain amount of images after alarm input is triggered.
Check the box to upload the triggered
images during certain time or keep uploading until the trigger is
off. Select and enter the duration in the blank.
The images of the duration will be uploading by E-mail when the
alarm input is triggered. The setting range is from 1 to 9999
seconds. Select to make the
images keep being uploaded to E-mail during the trigger active
until the alarm is released. Set the Image frequency as the upload
frame rate. The setting range is from 1 frame to 15 frames.
NOTE- Make sure SMTP configuration has been completed.
Please refer to Mail for further details.