Brickcom OSD-200 20xp - Manual (Page 51)

47
If the Motion Detection function is activated, the pop-up window (Motion) with
indication of motion will be shown.
When motion is detected, the signals will be displayed on the Motion window as
shown below.
A. Motion Detection
In each set of Motion Detection Setting, the default setting for the
Motion Detection function is . Enable the function by selecting
. Users can also activate the function according to the schedule
previously set in the setting page. Select
and click to choose the desired schedule from the
drop-down menu.
B. Motion Detection Setting
Users could adjust various parameters of Motion Detection in this
section.
a. Sampling pixel interval [1-10]:
The default value is 1. If the value is set as 3, it means within the
detection region, system will take one sampling pixel for every 3
pixels by each row and each column (refer to the figure below).