Brickcom OSD-200 20xp - Manual (Page 52)

48
b. Detection level [1-100]:
The default level is 10. The item is to set detection level for each
sampling pixel; the smaller the value, the more sensitive it is.
c. Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels
are detected differently, system will detect motion. The bigger the
value, the more sensitive it is. Meanwhile, when the value is bigger,
the red horizontal line in the motion indication window will be lower
accordingly.
d. Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each
detected motion.
C. Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion
is detected. All options are listed as follows:
a. Enable Alarm Output 1/2
Check the item and select the predefined type of alarm output to
enable alarm relay output when motion is detected.
b. Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by
FTP and/or E-Mail when motion is detected.
c. Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters. When motion is detected, event
images will be uploaded to the appointed FTP site.