Brickcom OSD-200 20xp - Manual (Page 10)

6
Chapter 3 - Device Appearance Description
< Bottom View >
Please refer to the illustrations below to connect power core through the supplied power
adaptor, and set up the audio according to the Audio pin definition.
< Power Connector>
NOTE- To power up the camera, please plug the AC 24V cable into the camera ’s
power connector (Operating Temperature: -40℃-50℃); Or connect the Ethernet cable to
the camera
’s Ethernet port and plug the other end of cable into an IEEE 802.3at High
Power over Ethernet (PoE plug)switch (Operating Temperature: -7℃-50℃)
Ethernet RJ45
10/100 Socket
Audio I/O
Micro SD Card Slot
Power
Factory Reset Button
Alarm I/O