Brickcom OSD-200 20xp - Manual (Page 46)

42
a. Alarm Setting
 Alarm Switch
The default setting for the Alarm Switch function is . Enable
the function by selecting . Users can also activate the
function according to the schedule previously set in the
setting page. Select and click
…> to choose the desired schedule from the
drop-down menu.
 Alarm Type
Select an alarm type, or , that
corresponds with the alarm application.
b. Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take at an alarm
occurrence. All options are listed as follows:
 Enable Alarm Output 1/2
Select these items to enable alarm relay outputs.
 Send Message by FTP/E-Mail
The Administrator can select whether to send an alarm message
by FTP and/or E-Mail when an alarm is triggered.
 Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters. When the alarm is triggered, event
images will be uploaded to the appointed FTP site.
function allows users to check what
happened to cause the trigger. The frame
rate could be pre-determined.
On the other hand, is for users to upload
certain amount of images after the alarm input is triggered.
Check the box to upload the triggered
images during certain time or keep uploading until the trigger is
off. Select and enter the duration in the blank.