Brickcom OSD-200 20xp - Manual (Page 53)

49
function allows users to check what happened to
cause the trigger. The frame rate could be
pre-determined.
On the other hand, is for users to upload certain
amount of images after motion event occurs.
Check the box to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select and enter the duration in the blank. The
images of the duration will be uploaded to FTP when the motion
event occurs. The setting range is from 1 to 9999 seconds. Select
to make the images keep being
uploaded to FTP during the trigger active until the event stops. Set
the Image frequency as the upload frame rate. The setting range is
from 1 frame to 15 frames.
NOTE- Make sure FTP configuration has been completed.
Refer to FTP for further details.
d. Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address
and configure various parameters. When motion is detected, event
images will be sent to the appointed e-mail address.
Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The frame rate could be
pre-determined.
On the other hand, is for users to upload certain
amount of images after the motion event occurs.
Check the box to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select and enter the duration in the blank. The
images of the duration will be uploading by E-mail when the motion
event occurs. The setting range is from 1 to 9999 seconds. Select
to make the images keep being
uploaded to E-mail during the trigger active until the event stops. Set
the Image frequency as the upload frame rate. The setting range is