Brickcom OSD-200 20xp - Manual (Page 39)

35
7.3 Network
The Network setting can be found under this path: System> Network.
Click on the category, there will be a drop-down menu with tabs
including , , , and .
7.3.1 Basic
The Basic setting can be found under this path: System> Network>
Basic.
Users can choose to connect to the IP Camera with fixed or dynamic
(DHCP) IP address. The IP Camera also provides PPPoE support for
users who connect to the network via PPP over Ethernet (PPPoE).
A. General
a. Get IP address automatically (DHCP)
The camera’s default setting is . Please refer
to User ’s Manual for login with the default IP address.
If select , after the IP Camera
restarts, users can search it through the installer program:
EasyConfig, which can be found in AutoRun Tool in the supplied CD.
NOTE- Please make the
record of the IP Camera’s MAC
address, which can be found in the label of the camera, for
identification in the future.
b. Use fixed IP address
To setup static IP address, select and move
the cursor to the IP address blank and insert the new IP address, ex.
192.168.7.123; then go to the Default gateway (explained later)
blank and change the setting, ex. 192.168.7.254. Press to
confirm the new setting.
 IP address- This is necessary for network identification.
 Subnet mask