Brickcom OSD-200 20xp User Manual
Page 54
50
from 1 frame to 15 frames.
NOTE- Make sure SMTP configuration has been completed.
Refer to
for further details.
e. Send HTTP notification
Check this item, select the destination HTTP address, and specify
the parameters for event notifications by
triggered. When an alarm is triggered, the notification can be sent to
the specified HTTP server.
For instance, if the custom parameter is set as
”
action=1&group=2
”,
and the HTTP server name is
” http://192.168.0.1/admin.php”, the
notification
will
be
sent
to
HTTP
server
as
”
http://192.168.0.1/admin.php?action=1&group=2
” when alarm is
triggered.
f. Record stream to SD Card
Select this item and the Motion Detection recording will be stored in
Micro SD / SDHC card when motion is detected.
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is
from 1 to 3 seconds. Select
duration after motion is triggered. The setting range is from 1 to 99999
seconds. Select
triggered video until the trigger is off.
NOTE- Please make sure the local recording (with Micro SD /
SDHC card) is activated so that this function can be implemented.
Refer to
Recording
for further details.
D. File Name
The uploaded image’s filename format can be set in this section. Please
select the one that meets your requirements.
E. Save
Please click on the
mentioned above.