YSI 5200A - Manual (Page 81)

YSI 5200A
160 YSI 5200A
161
written with more recent records. The number shown in ( ) at the Msg’s menu
reflects the total number of records in the log. The 25 most recent records for each
log are displayed at the
menu. Use ▲ ▼ to scroll and press

to view
time stamped detail record.
Use AquaManager to capture all records from 5200A logs and store them to a PC
database. Polling times should be determined by logging intervals. Example - if the
sensor log is recording values every minute and the sensor log holds 1000 records,
polling should occur at least every 27 hours. This would allow for all records to be
saved to the PC before being overwritten on the 5200A. Set the data log interval so
that analyzing data based on the configured interval will be helpful. Poll at intervals
that don’t result in gaps in data.
A Reset Clean Probe message will appear at the Msg’s Menu if the clean probe timer
expires. Selecting “Yes” at “Are you sure?” resets the clean probe timer to the user
configured number of days.
Note:
User configured sensor and relay names do not appear in log menus. -
Calibration Logs
Calibration logs store sensor calibration data. Calibration logs are date and time
stamped and contain sensor and calibration information for completed calibra-
tions.
Configuring the 5200A
Certain calibration data is not available at the 5200A. Use AquaManager to view
and save calibration data to the PC. In addition to sensor system, time, date, and
calibration method, AquaManager calibration logs include user input 1, user input
2, and the original and new slope/offset information when applicable.
Event Logs
Control, Alarm, and Timer relays assigned to 5200A systems create events when
they energize and de-energize. In addition, AC power fail and ethernet failure to
initialize errors create events. These events are recorded in the Event log. Events
identify the 5200A system, are time stamped, and record relay on and off times.
The General Alarm does not create an event or control message unless a General
Alarm relay is enabled.
Notes:
Enable event logging in the System menu. - See Event Logging - page 104
for additional information.
Sensor Logs
Enabled systems record sensor data based on data logging menu configuration.
Sensor logs identify sensor system, are date and time stamped, and record sensor
value at user configured intervals.
Configuring the 5200A