YSI 5200A - Manual (Page 116)

YSI 5200A
230 YSI 5200A
231
Index Index
network 93
RS232 baud rate 96
send test email 96
Conductivity
temperature compensation 138
timed and normal control 137
Conductivity calibration 75
Configuration chapter 63
Configuration log 102
contactor wiring. See Wiring contactor
Contact Us 226
Control board 40
Control menu 158
Control value 128
timed control-conductivity 137
timed control range high temperature 144
D
Daily feedings (Feed Smart timer) 152
Daily weight (Feed Smart timer fcr) 153
Daily weight (Feed Smart timer-non fcr) 152
Data Logging menu 102
clear logs 105
event log 104
sensor log (data log) 102
Date and Time menu 106
Declaration of conformity 218
defaults. See Factory defaults
device timed out error. See Firmware Updater
DHCP (ethernet menu) 89
Display format (aux analog) 101
Display settings menu 107
DNS address (ethernet menu) 91
DO membrane 5561 35, 36
DO sensor calibration mg/l 79
DO sensor calibration % sat 77
DO sensor setup 139
Dose time
conductivity control 137
pH control 142
Dwell time
conductivity control 137
pH control 142
E
Email addresses (ethernet menu) 91
Email alarming 86
5200A email 86
AquaManager email 86
email retry delay 96
send test email 96
Ethernet menu 88
DHCP 89
DNS address 91
email addresses 91
gateway 90
IP address 90
port 91
subnet mask 90
Ethernet module
configure communications ethernet menu 88
event log error message 92
installation 59
SMS messaging 93
Event logging 104
Event log view 161
Explorer window - AquaManager 168
F
Factory defaults 194, 195–240
fcr (feed timer) 153
Feed Smart Timer 149
biomass 153
calibrate 155
daily feedings 152
daily weight 153
fcr
biomass 153
daily weight 153
fcr factor 154