YSI 5200A User Manual
Page 49
YSI 5200A
96
YSI 5200A
97
Send Test Email Msg
Menus → System → Communications → Send Test Email Msg
Send a test email to verify proper configuration of ethernet menus. Test emails are
only transmitted from configured master 5200As.
Note:
Exit to Run Screen is required before the test email is sent.
-
Example of a 5200A test email sent from an ethernet device:
Subject Line: 02/04/10 03:50:05 PM YSI5200A Email Alarm Test Message
From: [email protected]
Sent: Wed, Feb 04, 2010 3:49 pm
Email Retry Delay
Menus → System → Communications → Email Retry Delay
Configure the Email Retry Delay for the time interval that emails should be retrans-
mitted after the initial alarm email is sent. The initial alarm email is sent immediately
after the general alarm hold off time or after the aux hold off time. Emails will be
retransmitted until one of the bottom front panel softkeys is pressed, regardless if
the alarm condition still exists.
Note:
On a network, emails are retransmitted according to the slave retry delay
-
configuration of the slave in alarm and not the master’s email retry delay
configuration. Please note, a slave Email Retry Delay menu will display
(Not available) because of its slave configuration; however, this feature
is available and has a default value of 15 minutes that can be configured
by the user.
The Retry Delay should be configured at intervals ≥ 15 minutes.
-
AquaManager alarm emails are retransmitted based on the 5200A slave(s)
-
and master email retry delay configuration.
Baud Rate RS232
Menus → System → Communications → Baud Rate
Configure the Baud rate (for RS232 connections only) in the 5200A to match the
baud rate configured in AquaManager. Use the default rate of 115200 for fastest
communication speed.
Configuring the 5200A
Enter Network menu
1.
Menus → System → Communications → Network →Baud Rate
Press
2.
▲
or
▼
to scroll and highlight a selection.
Press
3.
to confirm selection.
Press
4.
to save configuration and return to Run Screen.
Force Serial Port
Menus → System → Communications → Force Serial Port
Enable the Force Serial Port when the 5200A is communicating via RS232 (direct)
to a PC and when the 5200A has a serial to ethernet device.
Wire RS232 connection -
1.
page 58
Enter Network menu
2.
Menus → System → Communications → Force Serial Port
Use the
3.
softkeys to configure off or on.
Press
4.
to save configuration and return to Run Screen.
Notes:
RS232 connection is required to upload firmware using the Firmware
-
Updater.
The RS232 icon
-
blinks at the Run Screen when in Force Serial Port
mode.
Configuring the 5200A