C2G 52064 Single Port KVM over IP - Manual (Page 80)

Single Port KVM over IP
78 / 88
version number of the uploaded firmware. Pressing the button “Update” will
store the new version and substitute the old one completely.
Warning
This process is not reversible and might take some minutes. Make sure
the IP-KVM switch's power supply will not be interrupted during the
update process, because this may cause an unusable card.
•
Thirdly, after the firmware has been stored, the panel will request you to reset
the IP-KVM switch manually. Half a minute after the reset, the IP-KVM switch
will run with the new firmware version and should be accessible. However, you
are requested to login once again.
Warning
The three-stage firmware update process and complete consistency
check are making a mistake in updating the firmware almost impossible.
However, only experienced staff members or administrators should
perform a firmware update. Make sure the IP-KVM switch's power supply
will not be interrupted!
6.7.4 Unit Reset
Figure 6-38 Unit Reset
This section allows you to reset specific parts of the device. This involves the both
keyboard and mouse, the video engine and the IP-KVM switch itself. Resetting the
card itself is mainly needed to activate a newly updated firmware. It will close all
current connections to the administration console and to the Remote Console.