C2G 52064 Single Port KVM over IP - Manual (Page 49)

Single Port KVM over IP
47 / 88
To create a CDROM image file, copy the contents of the CDROM to a file. You
can use the following command:
dd [ if=/dev/cdrom ] [ of=/tmp/cdrom.image ]
dd reads the entire disc from the device /dev/cdrom, and saves the output in the
specified output file /tmp/cdrom.image. Adjust both parameters exactly to your
needs (input device etc.).
MS Windows
To create the image file, use your favorite CD imaging tool. Copy the whole
contents of the disc into one single image file on your hard disk.
For example, with “Nero” you choose “Copy and Backup”. Then, navigate to the
“Copy Disc” section. Select the CD ROM or DVD drive you would like to create an
image from. Specify the filename of the image, and save the CD ROM content in
that file.
Figure 6-13. Nero selection dialog