C2G 29999 PORT AUTHORITY 3-PORT FIREWIRE PCI CARD - Manual

PORT AUTHORITY 3-PORT FIREWIRE PCI CARD MANUAL
System Requirements:
Hardware:
• PC with standard PCI slot
Software:
• Windows® 98SE/ME/2000/XP
Package Contents:
• Installation Guide
• The Port Authority FireWire (IEEE-1394) PCI Card
• This manual
Installing the IEEE1394a PCI Card
In this section we will explain how to install your IEEE1394a PCI Card into your PC. Next to
each step there is a check box for your convenience. After each step has been completed, mark
the check box and move to the next step.
Step1 Power off the computer, then disconnect the power cord.
Step2 Remove each screw found on the back of the computer to open the computer’s case.
Step3 With the power cable disconnected from your computer, touch the metal part of the
case to ground yourself. This will discharge any static electricity that can damage your computer.
Step4 Locate an available PCI expansion slot. This will be in the area of your computer
where other cards that look similar to the IEEE1394a PCI Card are installed
Step5 Visually confirm that the IEEE1394a PCI Card will fit into the available slot you have
chosen.
Step6 If necessary, remove the knockout on the back of the PC that corresponds to the PCI
slot you have confirmed as your selection. If there is a screw, place it in a safe place as you will
be using it to attach the IEEE1394a PCI Card.
Step7 Push the IEEE1394a PCI Card firmly into the PCI slot. Apply pressure as needed until
the edge connector is completely sealed.
Step8 Once the IEEE1394a PCI Card is fully seated, the gold edge connectors should fit
completely in the slot.
Step9 Mount the IEEE1394a PCI Cardin place with a screw. Make sure the screw is firmly
tightened so the card does not slide out of its seated position.
Step10 Replace the computers case and screw it in place.
Step11 Now that your IEEE1394a PCI Card is installed, you can safely connect the power
cable.
Software driver installation
The versions of Windows listed above have built-in support for this FireWire card. No additional
drivers are required. When you first power on your PC after installing the card, Windows will
automatically detect the new device and start the New Hardware Wizard. Please follow the step-
by-step instructions below on how to properly install the required software drivers.
Follow the steps listed below to install the Windows
® 98 SE/ME drivers:
1. Turn on your computer with Windows® 98SE/ME.
2. When the Add New Hardware Wizard appears, click Next .