C2G 52064 Single Port KVM over IP - Manual (Page 10)

Single Port KVM over IP
8 / 88
IP-KVM switch Setup Tool
If this initial configuration does not meet your local requirements, use the setup tool to
change the configurations to your needs. The setup tool PSetup can be found on the
CD ROM delivered with this package. You can follow the procedures described below.
1. DHCP
If you have installed the IP-KVM switch on a network that enables DHCP, you can
use the PSetup to find out the IP-KVM switch’s IP.
(1) Plug Ethernet cable to IP-KVM switch. IP-KVM will get an IP via DHCP.
(2) Using PSetup (run PSetup.exe) to look for IP-KVM.
a. Select MAC address which label on bottom of IP-KVM switch
b. Click Query Device
2. Setup fixed IP
a. Setup “IP auto configuration” as “None” ; setup IP address and Subnet mask
b. Enter Super user login and password for Authentication (default : super/pass)
c. Click Setup Device. If super login was authenticated, it’ll show “Successfully
configured device”. Otherwise it’ll show “Permission Denied”.