C2G 52064 Single Port KVM over IP - Manual (Page 65)

Single Port KVM over IP
63 / 88
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the IP-KVM switch should be accessible from networks other than the
local one, this IP address must be set to the local network router's IP address.
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option
may be left empty, however the IP-KVM switch will not be able to perform
name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be
used in case the Primary DNS Server cannot be contacted.
Remote Console And HTTPS port
Port number at which the IP-KVM switch's Remote Console server and
HTTPS server are listening. If left empty the default value will be used.
HTTP port
Port number at which the IP-KVM switch's HTTP server is listening. If left
empty the default value will be used.
Telnet port
Port number at which the IP-KVM switch's Telnet server is listening. If left
empty the default value will be used.
Bandwidth limitation
The maximum network traffic generated through the IP-KVM switch ethernet
device. Value in Kbit/s.
Enable Telnet access
Set this option to allow accessing the IP-KVM switch using the Telnet
Gateway see the section 6.1.2 ).
Disable Setup Protocol
Enable this option to exclude the IP-KVM switch from the setup protocol.
Setup protocol is a proprietary layer-2 MAC-based protocol to allow some
configuration software to detect IP-KVM devices in the network, even without
IP address, and then config network related settings to IP-KVM switch..
LAN Interface Settings
The “Autodetect” will set the ethernet speed to the fastest possible value
supported by both endpoints of the link. For example, if you use a 10M/half
duplex HUB, this speed will be auto-selected. If this option does not work with