C2G 52064 Single Port KVM over IP - Manual (Page 64)

Single Port KVM over IP
62 / 88
6.6 Device Settings
6.6.1 Network
The Network Settings panel as shown in Figure 6-24 allows changing network
related parameters. Each parameter will be explained below. Once applied the
new network settings will immediately come into effect.
Figure 6-24. Network Settings
Warning
The initial IP configuration is usually done directly at the host system using
the special procedure described in Table 4-1.
Warning
Changing the network settings of the IP-KVM switch might result in losing
connection to it. In case you change the settings remotely make sure that
all the values are correct and you still have an option to access the
IP-KVM switch.
IP auto configuration
With this option you can control if the IP-KVM switch should fetch its network
settings from a DHCP or BOOTP server. For DHCP, select “dhcp” , and for
BOOTP select “bootp” accordingly. If you choose “none” then IP auto
configuration is disabled.