C2G 52064 Single Port KVM over IP - Manual (Page 73)

Single Port KVM over IP
71 / 88
Serial line speed
The speed the IP-KVM switch is communicating with the modem. Most of
all modems available today will support the default value of 115200 bps. In
case you are using an old modem and discovering problems try to lower
this speed.
Modem Init String
The initialization string used by the IP-KVM switch to initialize the modem.
The default value will work with all modern standard modems directly
connected to a telephone line. In case you have a special modem or the
modem is connected to a local telephone switch that requires a special dial
sequence in order to establish a connection to the public telephone
network, you can change this setting by giving a new string. Refer to the
modem's manual about the AT command syntax.
Modem server IP address
This IP address will be assigned to the IP-KVM switch itself during the PPP
handshake. Since it is a point-to-point IP connection virtually every IP
address is possible but you must make sure, it is not interfering with the IP
settings of the IP-KVM switch and your console computer. The default
value will work in most cases.
Modem client IP address
This IP address will be assigned to your console computer during the PPP
handshake. Since it is a point-to-point IP connection virtually every IP
address is possible but you must make sure, it is not interfering with the IP
settings of the IP-KVM switch and your console computer. The default
value will work in most cases.
Passthrough access to serial port via Telnet
Using this option, it is possible to connect an arbitrary device to the serial port
and access it (assuming it provides terminal support) via Telnet. Select the
appropriate options for the serial port and use the Telnet Console, or a
standard Telnet client to connect to the IP-KVM switch .
IP-Power
Serial port of IP-KVM connect to serial power device for Remote Power Control
through proprietary protocol.