GE Industrial Solutions AF-300 P11_G11 Ethernet Interface - Manual (Page 45)

Appendix C – Ethernet/IP Objects 39
Identity Object, Class 0x01
Services
Class services Get Attribute All
Get Attribute Single
Instance services Get Attribute All
Get Attribute Single
Reset
Class Attributes
# Access Name Type Value Description
1 Get Revision UINT 0x0001 Revision 1
Instance Attributes
# Access Name Type Value Description
1 Get Vendor ID UINT 0x005A HMS Industrial Networks AB
2 Get Device type UINT 0x000C Communication Adapter
3 Get Product code UINT 0x012C OPC-G11S-ETN drive adapter
Struct of: - Version X.YY
USINT XX Major product version of this
communication module.
4 Get Revision
USINT YY Minor product version of this
communication module
5 Get Status WORD - Status of the device, see table
below.
6 Get Serial number UDINT Serial
number
This is the serial number of the
product, assigned when the module
is produced.
7 Get Product name SHORT_S
TRING “OPC-
G11S-
ETN” The module’s product name.
Status Attribute Extended Device Status (Bit 4-7)
Bit 0 Owned, shall be set when at least one
connection is configured.
Bit 1 Reserved, set to 0.
Bit 2 Configured, is always set to 1.
Bit 3 Reserved, set to 0.
Bit 4-7 See extended device status
Bit 8 Is set for minor recoverable faults.
Bit 9 Is set for minor recoverable faults.
Bit 10 Is set for major recoverable faults.
Bit 11 Is set for major unrecoverable faults.
Bit 12-15 Reserved, set to 0.
0000 = Unknown
0010 = Faulted I/O connection
0011 = No I/O connection established
0100 = Non volatile configuration bad
0110 = Connection in run mode
0111 = Connection in idle mode