GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 31)

GEH-6412 Toolbox for AV-300i Version 2 Drive Chapter 4 Configuring an AV-300i Version 2 Drive •••• 4-1
Chapter 4 Configuring an AV-300i
Version 2 Drive
Introduction
This chapter provides instructions for using the toolbox to configure and monitor an
AV-300i Version 2 drive. In addition, information on using other features of the
toolbox specific to the drive is also provided.
Section Page
Creating an AV-300i Version 2 Drive.................................................................. 4-1
Configuring the Drive ......................................................................................... 4-4
Working with Files and Menus............................................................................ 4-6
Concepts ............................................................................................................4-15
Configuration.....................................................................................................4-16
Block Diagram...................................................................................................4-20
Drive Controls ...................................................................................................4-23
Wizards .............................................................................................................4-23
Fault Display......................................................................................................4-25
Self-Tune...........................................................................................................4-26
Using the Finder.................................................................................................4-30
ISBus Configuration...........................................................................................4-31
Genius Configuration .........................................................................................4-35
Creating an AV-300i Version 2 Drive
When the toolbox starts, the toolbox Work Area displays (refer to the section,
Configuring the Drive). The Work Area is used to maintain the drive configuration
file in the toolbox. You must create a new drive configuration file (.acb) or open an
existing one.
Or click New
Ш Ш Ш Ш To create an AV-300i Version 2 drive
w From the File menu, select New. The New dialog box contains the installed
toolbox products.