Hz frequency, Hz solo, Output – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 434: Power, Hz solo” on, The complete “mixed” effect is heard
UAD Powered Plug-Ins Manual
- 434 -
Chapter 41: Precision Enhancer Hz
Hz Frequency
Through filter isolation of the original bass content,
the Hz Frequency parameter defines the cutoff fre-
quency for the enhancement process. Frequencies be-
low this value are enhanced by the processor. The
available range is 16 Hz to 320 Hz.
Hz Solo
Hz Solo isolates the original bass signal and can be combined with Ef-
fect Solo. Hz Solo is active when the button is red.
Output
Output controls the signal level that is output
from the plug-in. The available range is –20
dB to 0 dB.
Generally speaking, adjust the Output control
after the desired amount of processing is achieved with the Effect and Hz Fre-
quency controls. Output does not affect the amount of enhancement process-
ing, nor does it have any effect when the plug-in is disabled.
Output Meter
The stereo Output Meter displays the signal level at the output of the plug-in.
When the plug-in is disabled with the plug-in Power switch (but not the host
plug-in enable switch), the output meters still function.
Power
The Power switch determines whether the plug-in is active. This
is useful for comparing the processed settings to the original
signal or bypassing the plug-in to reduce the UAD DSP load
(load is not reduced if
“UAD-2 DSP LoadLock” on page 74
enabled).
Toggle the switch or click the UA logo to change the Power state. The UA logo
is illuminated in blue when the plug-in is active.
Note:
You can click-hold the power switch then drag it like a slider to quickly
compare the enabled/disabled state.