Uad-2 satellite operation, About firewire, Power indicator – Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 133: Rear panel led, Uad-2 satellite authorization
UAD Powered Plug-Ins Manual
- 133 -
Chapter 11: UAD-2 Satellite
UAD-2 Satellite Operation
After UAD Powered Plug-Ins software v5.8.1 (or higher) is installed (
and UAD-2 Satellite is properly connected to the computer via FireWire
(
), the system is ready for use. Refer to other chapters in this manual
for software operating instructions.
All UAD-2 Satellite operations (except for hardware setup) are similar to the
operation of other UAD-1/UAD-1e/UAD-2 devices. See
for exceptions specific to UAD-2 Satellite.
About FireWire
For general information about FireWire and how it is used with UAD-2 Satel-
lite and other FireWire devices, see
and
“FireWire Bandwidth” on page 141
It is important to note that available FireWire bandwidth is unrelated to UAD
DSP loads. See
“FireWire Bandwidth vs. UAD DSP” on page 143
for details.
Power Indicator
When power is applied to UAD-2 Satellite via the rear switch, the UA logo on
the front panel glows. This power indicator does not represent the state of the
UAD drivers or their link to UAD-2 Satellite (the
operational state).
Rear Panel LED
UAD-2 Satellite has a UAD link indicator on the rear panel. This LED provides
information about the operational state of the device and its drivers. For more
details, see
.
UAD-2 Satellite
Authorization
After initial setup and before first use, UAD-2 Satellite should be registered
and authorized (it can run in demo mode for 14 days without authorization).
See
for full explanation and procedures.
Figure 30. UAD-2 Satellite Power Indicator
Figure 31. UAD-2 LED on Satellite rear panel