Universal Audio UAD POWERED PLUG-INS ver.6.1 - Manual (Page 126)

UAD Powered Plug-Ins Manual - 126 - Chapter 10: UAD ExpressCard Products
2.
Power down the ExpressCard, using the following method as defined by
the operating system:
• (Windows) In the Windows Task Bar, click the Safely Remove Hardware
icon, and select “Safely remove Universal Audio UAD-1 DSP card”
(
Figure 26 on page 126 ).
• (Mac) In the Menu Bar, click the ExpressCard status menu icon, and select
“Power off Card” (
Figure 27 on page 126 )
3.
Turn off the power switch on the back of the UAD-Xpander.
4.
Remove the UAD ExpressCard from the expansion slot.
UAD-Xpander disconnection is complete.
Reconnect Once the UAD-Xpander has been disconnected for any reason, the computer
must be rebooted with the UAD-Xpander connected. Follow the
“Startup Se-
quence” on page 124 for reconnection instructions.
System Sleep
Windows System Sleep (hibernate) is not supported when using UAD-Xpander under
Windows. Sleep should be disabled while the UAD-Xpander is connected.
Figure 26. ExpressCard Power Down (Windows)
Figure 27. ExpressCard Power Down (Mac)