Universal Audio UAD POWERED PLUG-INS ver.6.1 - Manual (Page 297)

UAD Powered Plug-Ins Manual - 297 - Chapter 27: Lexicon 224
When configured as mono-in/mono-out (“MIMO”), output A is used exclu-
sively except in programs 2, 4, and 9, where outputs A and C are summed
into one monophonic signal. This implementation is recommended in the orig-
inal hardware manual. If Rear Outs is enabled in MIMO mode, outputs B and
D are used instead of A and C. See
Table 21 on page 311 for a list of outputs
used with each program in this configuration.
Primary &
Hidden Controls
The primary controls (those that are most typically used) are on the main “re-
mote control” panel interface. Additional (less typically used) controls are
available in a hidden control panel. The hidden control panel (
Figure 102 on
page 306 ) is accessed by clicking the “OPEN” text label to the right of the
Display Panel.
For detailed descriptions of all parameters, see “Primary Controls” on
page 299 and “Hidden Controls” on page 306 .
Parameter
Ranges &
Default Values
The parameter value ranges, default values, and availability of particular pa-
rameters within a given program may vary depending on which program is
active. Parameter ranges are listed in the individual control descriptions. De-
fault parameter values for each program are listed in
Table 22 on page 311 .
Note: Extreme parameter settings can cause Lexicon 224 to self-oscillate or
cause other unexpected sounds. This behavior is identical to the original hard-
ware.
Display Panel The Lexicon 224 display panel ( Figure 100 below) consists of four display el-
ements: Numerical Value, LED Value, Stereo Level Meters, and Overflow in-
dicator. Exactly what is displayed here is dependent on the parameter being
edited (if any) and the state of the
Display Hold switch ( page 308 ).
Numerical Value
The three-character Numerical Value Display shows the value of parameters
as they are being edited. The value of the edited parameter is displayed for
1.5 seconds unless the
Display Hold switch is set to infinite, in which case the
last edited parameter value continues to be displayed.
Figure 100. The Lexicon 224 Display Panel