Universal Audio UAD POWERED PLUG-INS ver.6.1 User Manual
Page 29
UAD Powered Plug-Ins Manual
- 29 -
Chapter 2: UAD Installation
3.
When installation has completed, power down your system to install the
UAD card(s) following the instructions on
. If the UAD device is al-
ready installed or you are updating, restart the system.
4.
After restarting, the New Hardware Wizard will try to locate the new driv-
ers. Follow these steps:
• a) Select the “Install the software automatically (Recommended)” option,
and click “Next.”
• b) The UAD device driver will be installed, click “Finish” when it is complete.
• c) (UAD-1 only) The New Hardware Wizard will run again to look for the
second UAD-1 driver. Select the “Install the software automatically (Recom-
mended)” option, and click “Next.” The second UAD-1 driver will be in-
stalled; click “Finish” when it’s complete.
Software installation is now complete. Proceed to the Authorization section (
You can use the UAD Meter & Control Panel to verify installation (see
Note:
If you want to install the UAD plug-ins into another application, run the
installer again.
Mac Install
Software Installation Procedure for Mac Systems
Important:
Verify the computer system date and time are set correctly be-
fore installing the software and/or launching the UAD Meter & Control Panel
application for the first time.
1.
Launch the software installer.
• To install from CD-ROM, insert the UAD Powered Plug-Ins CD. Open the CD
window, then double-click the application named “UAD Powered Plug-Ins
Installer.”
• To install from a download, first decompress the downloaded .zip archive
by double-clicking it. Then double-click the UAD Powered Plug-Ins Installer
application.
2.
The installer will guide you through the installation procedure.
3.
Restart the computer after the software is installed.
Software installation is now complete. Proceed to hardware installation or if that is done
already, proceed to the Authorization section (
).