SENA STS Series User Manual
Page 83
83
1. Prepare user file to be uploaded.
2. Connect the terminal emulation program using either TELNET/SSH or a serial console port.
(TELNET or SSH is recommended since the process of firmware upgrade by serial console.
Using a serial console port may take a long time.)
3. Select from the user file upload menu as shown Figure 6-13.
4. Follow the online directions and transfer the user file using the Zmodem protocol as shown in
Figure 6-11.
5. Once the upload has been completed, the system will display success messages as shown in
Figure 6-13.
6. If the upload fails, the STS Series will display error messages as shown in Figure 6-14.
Note: User file uploading is permitted only under user space (/usr2) directory. For more information
about file system inside STS Series, please refer to 8.2. Flash Partition section.
------------------------------------------------------------------------------
Welcome to STS-800 configuration page
Current time : 08/14/2003 11:56:13
F/W REV.
: v1.0.0
Serial No.
: STS800438349-42944
MAC address: 00-01-95-04-d3-03
IP mode
: DHCP
IP address : 192.168.222.206
------------------------------------------------------------------------------
Select menu:
1. Network configuration
2. Serial port configuration
3. PC Card configuration
4. System administration
5. Save changes
6. Exit without saving
7. Exit and apply changes
8. Exit and reboot
---> 4
------------------------------------------------------------------------------
System administration
------------------------------------------------------------------------------
Select menu:
1. System status
2. System logging
3. Device name: STS800 Device
4. Date and time
5. Change password
6. User file upload
7. Reload factory default settings
8. Reload factory default settings except IP settings
9. Firmware upgrade
---> 6
Do you want to upload a file to user space? (y/n): y
Enter a filename: test.txt
The file will be saved as /usr2/test.txt.
Transfer a file by zmodem using your terminal application.
To escape, press Ctrl+X.
**B01ff000005b157
Uploading a file is completed.
Figure 6-13 User file upload menu and success messages