SENA STS Series - Manual (Page 22)

22
3. Network Configuration
3.1. IP Configuration
The STS Series requires a valid IP address to operate within the user’s network environment. If the
IP address is not readily available, contact the system administrator to obtain a valid IP address for the
STS Series. Please note that the STS Series requires a unique IP address to connect to the user’s
network.
The users may choose one of three Internet protocols in setting up the STS Series IP address: i.e.,

Static IP

DHCP (Dynamic Host Configuration Protocol)

PPPoE (Point-to-Point Protocol over Ethernet)
The STS Series is initially defaulted to STATIC mode, with a static IP address of 192.168.161.5. Table
3-1 shows the configuration parameters for all three IP configurations. Figure 3-1 shows the actual
web-based GUI to change the user’s IP configuration.
Table 3-1 IP configuration Parameters
IP address
Subnet mask
Default gateway Static IP
Primary DNS/ Secondary DNS
DHCP Primary DNS/ Secondary DNS (Optional)
PPPoE Username
PPPoE Password
PPPoE
Primary DNS/ Secondary DNS (Optional)
Figure 3-1 IP Configuration