A 5.5. firmware upgrade menu – SENA STS Series User Manual
Page 118
118
A 5.5. Firmware Upgrade Menu
By using the ‘Firmware upgrade’ menu, the user can upgrade the firmware of the unit. Before firmware
upgrade, the user can check the current firmware version by selecting menu item 3 from the Main
menu page
.
The firmware upgrade menu program supports two protocols for remote firmware
download: BOOTP and TFTP. The default protocol is BOOTP for DHCP environments. If the user
selects TFTP, he must also set the IP address for the unit properly. The default IP address for the unit
is 192.168.161.5.
For firmware upgrade, a firmware file configured as [Firmware File Name] on the server configured as
[Server’s IP address] must exist.
-----------------------------------------------------------------------------
Firmware upgrade
-----------------------------------------------------------------------------
Select menu
1. Protocol [BOOTP]
2. IP address assigned to Ethernet interface [192.168.161.5]
3. Server's IP address [192.168.0.128]
4. Firmware File Name [sts800.bin]
5. Start firmware upgrade
-----> 1
Select protocol ( 1 = BOOTP, 2 = TFTP) : 2
-----------------------------------------------------------------------------
Firmware upgrade
-----------------------------------------------------------------------------
Select menu
1. Protocol [TFTP]
2. IP address assigned to Ethernet interface [192.168.161.5]
3. Server's IP address [192.168.0.128]
4. Firmware File Name [sts800.bin]
5. Start firmware upgrade
----->
Figure A-9 Firmware upgrade menu within Bootloader Menu Program
If the user selects [Start firmware upgrade], a confirm message will be displayed on the screen. If the
user enters ‘y’, the firmware upgrade process will start. This process cannot be stopped until it is
finished.
-----------------------------------------------------------------------------
Firmware upgrade
-----------------------------------------------------------------------------
Select menu
1. Protocol [BOOTP]
2. IP address assigned to Ethernet interface [192.168.161.5]
3. Server's IP address [192.168.0.128]
4. Firmware File Name [sts800.bin]