B&B Electronics MESP211D_T - Manual - Manual (Page 9)

Hardware Vlinx MESP211 Modbus Gateway
8
MODE SWITCH
A recessed momentary reset switch is located on the front left side of the enclosure. To
activate the switch, insert a small plastic tool through the hole in the enclosure and press
gently.
Mode/Reset Switch
Figure 2.
The Mode/Reset switch can be used to:
 Initiate a Hardware Reset
 Enter Console Mode
 Reload factory defaults
Note: Refer to Section 3: Modbus Gateway Setup and Connections for more information on
using the Mode switch.