B&B Electronics MESP211D_T - Manual - Manual (Page 45)

Setup and Connections Vlinx MESP211 Modbus Gateway
44
Direct IP Connection Figure 43.
INITIATING A HARDWARE RESET ON THE MODBUS GATEWAY
To initiate a Hardware Reset on the Modbus Gateway, press and hold the Mode switch
for 0 to 2 seconds, and then release it. The LED indicators respond as follows:
1. The Ready LED blinks while the button is being pressed.
2. When the Modbus Gateway has reset and rebooted into Normal Mode the Ready
LED will be blinking.
RELOADING FACTORY DEFAULTS
To reload Factory Defaults, press and hold the Mode switch for more than 10 seconds.
The LED indicators respond as follows:
1. The Ready LED blinks three times per second while the button is being pressed.
The Modbus Gateway reloads all factory default configuration parameters. When
the device has reset and rebooted the Ready LED will be blinking.
2. The LEDs go back to their normal states when the device resumes normal
operation.
Note: Factory default parameters are listed in Appendix A