B&B Electronics MESP211D_T - Manual - Manual (Page 29)

Setup and Connections Vlinx MESP211 Modbus Gateway
28
3. Connection Filter Mode controls which TCP clients are able to connect.
The default is: “and allow everyone to connect.”
a. You can select “allow specific IP addresses to connect.”
This filter is limited to 4 IP addresses.
b. You can select “a specific range of IP addresses to
connect.” This filter is limited to 4 IP address ranges
TCP Connection Filter “Allow Specific IP Addresses to Connect”
Figure 29.
c. Save settings by clicking the “Save” button.