B&B Electronics MESP211D_T - Manual - Manual (Page 34)

Setup and Connections Vlinx MESP211 Modbus Gateway
33
Modbus client, before reporting a 0Bh exception if it is selected. Number of
retries is limited to 5.
h. Milliseconds Modbus Message Timeout – This is the maximum amount of time
to wait for a response to the message. Valid value range is from 1 to 65535.
i. Milliseconds TX Delay – This is the minimum amount of time after receiving a
response before the next message can be sent out. Valid value range is from
1 to 65535.
j. Save settings by clicking the “Save” button.
8. Port 1 ID Remap
a. To access this screen, click the “Next” button or click the “Port 1 ID Remap”
link on the left side of the screen.
b. This screen allows you to set Modbus Slave ID Remap settings.
Port ID Remap Screen
Figure 34.