B&B Electronics ZXT9-IOA-KIT - Manual - Manual (Page 39)

Configuration & Operation
Manual Documentation Number: ZXTx-IO-x-4113m 33
c. Channel Number range is different for 900 MHz and 2.4 GHz Zlinx Xtreme I/Os. The table below shows the ranges and
commands in hexadecimal values:
Type/Range Xtreme Module
Channel Number
Range
Factory Default
ZXT24-IO-222R2 0x0C to 0x17 0x0C
ZXT9-IO-222R2 0x00 to 0x09 0x00
Fig 6-4 Channel Number Range
6.1.1.3 Network Identifier
a. The Network Identifier field must match the Network Identifier used by the device with which it will communicate.
b. If that device is another Zlinx Xtreme I/O Module, set its Network Identifier the same as the local I/O Module
c. If that device is a Modbus Radio Modem, its Network Identifier must be configured by using the Radio Modem
Configuration Manager to match that of the I/O module. Refer Radio Modem manual for configuration information.
d. The Network Identifier range is different for both radio types (2.4 GHz and 900 MHz). The table below shows the channel
number ranges in hexadecimal values.
Type/Range Xtreme Module Network
Identifier Range
Factory Default
ZXT24-IO-222R2 0x00 to 0xFF
0x00
ZXT9-IO-222R2 0x11 to 0xFF
0x11
Fig 6-5 Network Identifier Range
e. If the Network Identifier is changed to outside the default value, it must be matched in the other device as well.
6.1.1.4 Repeater Mode
a. Select the Repeater checkbox if the Zlinx Xtreme I/O Module is to be used as a repeater, re-broadcasting I/O data
received in Modbus or Peer-to-Peer modes.
The default value of the Repeater field is unchecked.
6.1.1.5 RF Data Rate
900 MHz Xtreme Modules allow you to configure the over-the-air RF Data Rate. Using 9600 baud on these modules
increases the effective range of the module.
This data rate may be configured for 9600 baud or 115200 baud.
NOTE: Repeater Mode can only be implemented on the ZXT9-IO-222R2 Xtreme I/O Modules.